A diy stone paver patio tutorial step 1.
Paver stone steps diy.
Begin digging your patio area.
The over dig is necessary to make sure that the outside edges of the stone remain stable during and after the installation.
How to build steps out of stone pavers step 1.
Rake the sand back with a 2 4 maintaining an even slope photo 11.
Stone or brick pavers require no mortar when properly set so the labor required to install them is considerably less than pouring concrete.
Using your excavator excavate to a depth of 9 inches image 2.
Ensure your steps all end up at the same height and that each step is 15 inches deep from front to back.
Then divide the net size of each step by the size of your pavers to see how many you need.
It ll tamp down later.
Next add a layer of landscaping fabric on top of the dirt.
Check the sand height against the top step by laying a paver on it.
How to build a patio.
The width of the compacted area will.
Mark the perimeter of the path using spray paint increasing the size by 6 inches for the over dig image 1.
Excavate 8 inches deep in the area in which the first step is installed.
This will aid in rainwater drainage under the.
The paver should sit about 1 4 in.
Once you know these dimensions you can work out how many steps you will build.
Lay down a layer of landscape fabric to cover the excavated area.
Take care not to step in the sand or compress it.
Start by digging out the area where you d like to place your stone paver patio.