O rings for straight thread tube fitting bosses.
O ring boss thread chart.
A straight thread not tapered is used so that the o ring seals under compression.
The seal is made when the o ring is squeezed into the chamfer.
The seal takes place by compressing the o ring into the chamfer.
The female port of the o ring boss has a sealing face chamfer and a straight thread.
O rings for straight thread tube fitting bosses this class of o rings is primarily utilized in hydraulic tubing and fittings up to 3000 psi.
The male connector has an o ring and a straight thread.
The female port has a straight thread a machined surface minimal spotface and a chamfer to ac cept the o ring.
Sometimes referred to as o ring boss the male connector has a straight thread and an o ring.
Special order o ring materials.
The threads hold the connection mechanically.
Sae o ring boss thread chart thread size measurement taken from outside diameter of male threads sae o ring boss fittings seal with an o ring at the base of the male fitting against a chamfered area on the female port.
Sae o ring boss is typically seen in porting applications such as cylinders pumps motors and valves.
The o ring seals against the machined seat on the female port.
Sae o ring o ring boss are straight thread fittings that seal using a o ring between the thread and the wrench flats of the fitting.
Because of their use in primarily high pressure applications these seals are normally supplied in 90 durometer material.
O ring fittings can be either adjustable or non adjustable.